Alarm.Com MyQ Manuel d'utilisateur télécharger pdf (Page 31)

Total Connect 2.0 Online Help Guide

– 29 –

Attachment Type

– If you want an email notification, choose between sending a Video Clip or Snapshot at-

tachment. Note, regardless of the choice, a video clip will always be stored in the event history.

Pre-Capture and Post Capture Length

– These two settings determine the beginning and end of the 10 second

period that is captured when motion is detected. For video a 10 second clip is captured, and for snapshots a

series of 10 are captured.

Interval

– Choose from 1 to 15 minutes before the next video motion can be captured. This setting helps re-

duce excessive notifications.

PIR, Motion, Capture, White LED camera options

– This enables you to set which Triggers will be used to

cause certain actions. Depending on the camera type, features that are not supported will be grayed out.

Triggers can be from a security system control panel input, the camera’s PIR detector, or video motion. One

or more may be selected.

1. Choose the triggered input(s) that will capture video:

• PIR – Triggered by the camera's PIR sensor. Will trigger on movement within the PIR sensor view.

There are no masking, sensitivity levels or adjustments. DO NOT choose if Motion detection is going

to be used.

• Motion – Triggered by video analytics within four user defined “Event Detection Areas”. Motion is de-

termined by comparing current and previous video frames. DO NOT choose if PIR detection is going

to be used.

2. Determine what action results from the triggered input:

• Capture – The video or snap shot is stored in the Event History and can be sent as an email notifica-

tion if desired.

• White Light LED – The camera's white light LEDs turn on for the 10 second video motion capture pe-

riod. (This works only when the room is dark.)

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 49 50

Pas de commentaire

Alarm.Com MyQ Manuel d'utilisateur Page 31